Be careful not to place some hard objects or at noon on the 25L plastic bucket, such as flower pots, water basins, buckets, water tank covers, etc., otherwise it will cause scratches on the surface of the 25L plastic bucket and even crack the 25L plastic bucket. It is strictly prohibited to use strong acid or carbon and other decontamination powder to clean the 25L plastic bucket, and it is also strictly prohibited to use vaporizer Some chemicals such as diluent will cause corrosion on the surface of the 25L plastic bucket if it is cleaned.

It is strictly prohibited to use sharp equipment such as wire brush or blade to clean the 25L plastic bucket, otherwise the 25L plastic bucket will be simply scratched. 25 liters Plastic bucket manufacturer When turning it over for use, do not lean back hard, or the 25L plastic bucket will simply break. When using, it should be closed and opened gently to avoid scar caused by collision with the water tank. Now, the plastic tray industry has entered a period of rapid development. If plastic bucket manufacturers want to carry out, environmental protection transformation is inevitable.

Bubble appearance is a common problem in injection molding, which often occurs at the joints or thicker parts of plastic injection molding products. In the model, the surface of the product is cooled first. When the external surface is cooled, the central part is still hot.

The central part should be shortened when cooling, and the plastic surface has been cooled, so it can only be shortened from the inside to form bubbles. There are many thick parts without bubbles when they are cast, but after tens of seconds, bubbles appear in the center. Bubbles have several conditions, different phenomena and different reasons. The appearance becomes fat and rises, and there are bubbles at the sawed section. The reason may be that the injection speed is too fast, which encloses the air and cannot be eliminated, forming bubbles.

This phenomenon also occurs when the feeding amount is too much or too little, and the injection pressure is too high. If the feeding amount in the plastic injection molding process is properly adjusted, this phenomenon will be improved. The cooling time is too short (especially for thick wall plastic injection molding products). The treatment method can use cold water and cold pressing die outside the plastic injection molding machine for cooling.

The 25L plastic bucket is made of plastic, so we can handle the crack problem of plastic ton bucket from the material characteristics. Select the same material as standby. Use high-temperature metal material to make the hole of the 25L plastic bucket soften and stick to the touch of the standby material. After cooling for a while, it can be used normally.

Xi'an plastic bucket ——Find a section of plastic material with the same quality as your bucket and ignite it with fire, then drop the melted plastic liquid to the leaking place, and melt it more and more times, so that the interface will be more solid.