stay Plastic bucket production During the process, bubbles were found on the barrel wall at an early stage, which seriously reduced the Plastic bucket Its quality and output have brought serious economic losses to enterprises. So how to solve the bubble problem in the plastic bucket?

1. Improve the exhaust condition of the plastic bucket mold.

2. Increase the temperature of the plastic to make it flow smoothly. Reducing the temperature of plastic can reduce its shrinkage rate. Properly increasing the temperature of injection mold, especially the local mold temperature of parts prone to forming vacuum bubbles, can reduce the probability of bubbles.

3. In order to increase the energy of plastic injection, the pressure, speed, time and material consumption of injection molding should be increased. At the same time, the back pressure should be increased to make the plastic filler fuller.

4. When the plastic enters a warm environment, its moisture will condense on the cold plastic. Dry plastic can solve this problem.

5. If the plastic flow in the plastic bucket mold is uneven, resulting in air trapped in it, the method of vacuum exhaust on the mold can be used to solve this problem.

Generally, bubbles on the wall of plastic bucket or light color bucket can be directly observed, while bubbles on the wall of dark color bucket are sometimes difficult to see from the appearance, and can only be found by planing the bucket wall during the test. If it is not found in time, quality accidents will occur where products are delivered to customers, which will bring immeasurable losses to the future cooperation between enterprises and customers. Therefore, once found, it should be handled in time to avoid unnecessary losses.